- Kills germs and eliminates odors in one step
- Gentle on users, animals, and equipment
- Effective against a broad spectrum of fungi, bacteria, and viruses
- Works in minutes
- Contains hydrogen peroxide
Harmful if swallowed. Causes moderate eye irritation. Avoid contact with eyes or clothing. Wear chemical splash-proof googles or face shield. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum or using tobacco.
Storage: Store in original container. Keep securely closed. For long term storage store at 59-86 degrees Fahrenheit.
Keep out of direct sunlight. Climate controlled room is preferred for storage.
Disposal: Do not reuse or refill empty container. Clean container promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container ¼ full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Wrap and put in trash or offer for recycling.
Dispose of used wipes in the trash
Do not contaminate water, food or feed by storage of disposal.
Shelf Life:
Concentrate: 3 years, 90 days diluted (meets stability testing for up to 90 days after dilution with tap water.
Ready to Use and Wipes: 2 years
1. Pre-clean heavily soiled areas.
2. Depending on use, apply properly diluted solution until thoroughly wet.
3. Let stand for 5 minutes (10 minutes for canine parvovirus, mold and mildew).
4. Wipe surfaces and let air dry.
Dilutions per one gallon water
For use as a: Bactericidal and fungicidal- 5 minutes at 1:16 dilution
Virucidal- 5 minutes at 1:16 to 1:64 dilution
Non-food contact surface sanitizer- 3 minutes at 1:128 dilution
Ready to Use: Does not come with a sprayer.
1. Pre-clean heavily soiled areas.
2. Spray 6 to 8 inches from surface.
3. Allow surface to remain wet for 1 minute (4 minutes to kill mold and mildew).
4. Wipe surfaces dry or allow to air dry.
For use as a: Virucidal and fungicidal- 30 seconds to 1 minute
Bactericidal and tuberculocidal- 1 minute
Broad spectrum non-food contact surface sanitizer- 10 seconds
Soft surface sanitizer- 30 seconds
Wipes:
1. Pre-clean heavily soiled areas.
2. Pull towelette from canister and wipe hard, non-porous environmental surfaces.
3. Allow the surface to remain wet for 1 minute (4 minutes to kill mold and mildew). Use additional towelettes if needed to ensure the correct wet contact time.
4. Wipe surfaces dry or allow to air dry.
5. Change towelette after each use.
For use as a: Virucidal and fungicidal- 30 seconds to 1 minute
Bactericidal and tuberculocidal- 1 minute
Broad spectrum non-food contact surface sanitizer- 10 seconds
Active Ingredient: Hydrogen Peroxide 0.5%
Other Ingredients: 99.5%
Concentrate:
Active Ingredient: Hydrogen Peroxide 4.25%
Other ingredients: 95.75%